Making sure your measurements

asima25

The you are afraid of touching the cut light strip or circuit board. Measure the required length Be sure to measure the required length before cutting the light strip. Use a ruler or measuring tool to measure exactly where the light strip needs to be cut.   are accurate will help you avoid wasting light strips and ensure you have the exact length you need. Locate the Cut Point Follow the manufacturer's instructions to find the cut point on the light strip. These points are usually marked in a specific way and may consist of two vertical lines, small holes or other shapes.

Always make sure you have identified the correct cutting points to avoid damaging the strip. Cutting the light strip After finding the cutting point, use sharp scissors or professional light strip scissors Portugal WhatsApp Number List to carefully cut the light strip along the cutting point. Make sure the scissor blades completely cover the cutting point to avoid breaking the circuit. Be sure to use even force when cutting to avoid damaging the lamp beads or circuit board. After cutting, you can leave the flat end without exposed wires to make it easier to connect to the power supply.




Light Strip Test After cutting is completed, connect the light strip to a suitable power source and test it. Make sure everything is working properly and there are no circuit problems. If the light strip works normally, congratulations on successful cutting and installation of the light strip. Please observe the following precautions when cutting the light strip. Do not cut the light strip at will beyond the cutting point, otherwise it may damage the circuit and cause the lamp bead to fail. Avoid using excessive force when cutting to avoid damage or circuitry. If you're not sure how to properly cut light strips we recommend consulting the detailed instructions provided by the manufacturer or contacting a professional How to Install.